​arduino nano plc board

​This is an arduino nano expansion board that simulates the fuctionality of a P.L.C.
The board is design to eliminate the enviroment and ground noises so the arduino can safely run your programs without unexpected resets and abdnormal behaviours.

3 floor elevator arduino project

The board was designed for an elevator project of mine. The elevator project that you can read about it at the instractables page here: ​http://www.instructables.com/id/3-floor-elevator-arduino/

KEY FEATURES

-Easy arduino replacements with female pin headers
-Zero noises from the ground and the enviroment.
-No resets. No abdnormal behaviours.
-Posibility to power up the arduino circuit from seperate power supply or by usb power(recomended)
-Optoisolation for both inputs and outputs.
-Isolation for reseting the arduino with relay
-3 Ready relay outputs with N.O./COM/N.O.
-2 Trimmers connected directly to analogue inputs
-Easy din - rail mount  base
-Easy wiring via terminal blocks.

Part list for the kit

  • 17 x 10kohm smd 1206 resistors for the inputs and reset
  • 6 x 1kohm smd 1206 resistors for the outputs
  • 4 x cube relay nc/no 12 volt coil for 12 volt projects or 24 volt coil for 24 volt projects
  • 11 x pc817 optocoupler
  • 4 x 1n4001 diodes
  • 1 x buzzer
  • 3 x 2n3904 npn transistors
  • 4 x 470 uf capacitors at 25Vdc or 35Vdc
  • 1 x 100nf ceramic capacitor for the reset
  • 2 x blue trimmer 50kohm for analogue inputs
  • terminal blocks for connections
  • arduino nano